The Effects of Pouring Concrete in Cold Weather

The Effects of Pouring Concrete in Cold WeatherFirst, let’s define cold weather with respect to concrete. Any time you have 3 consecutive days where the average daily temperature is less than 40°F or if the temperature is lower than 50°F for less than half of any of the 3 days, concrete thinks it’s cold. Pouring concrete in cold weather can have a detrimental affect on concrete curing for several reasons.

Concrete transforms from a liquid to a solid material through a chemical reaction. The speed of the reaction depends upon the temperature of the concrete. When the weather is warm, the reaction proceeds quickly. When it’s cold and the ground hasn’t been thawed, the reaction slows down. That’s the problem: the concrete needs to harden as rapidly as possible to resist pressures caused by water freezing within the concrete.

If the temperature is too cold, the concrete may not have reached a minimum strength of 500 psi soon enough to resist the effects of freezing temperatures. If your concrete isn’t protected with concrete curing blankets after it’s poured, it may cool too rapidly, slowing the chemical reaction.

Poor finishing techniques can also doom your slabs. Freshly poured concrete often bleeds. The water in the mix floats to the top, since it’s the lightest ingredient. Floating or troweling this water into the concrete weakens the top layer. Troweling the concrete too early can seal this bleed water just below the surface as well. If your slab is then exposed to freezing temperatures several days later, this water can freeze and fracture the top layer. Using a concrete curing blanket can eliminate the potential of freezing.


Concrete can be successfully poured in cold weather.

Several precautions need to be taken:

  • Be sure to order air-entrained concrete. Request a heated mix or order 100 lbs of extra cement for each cubic yard of concrete. This extra cement helps develop early strength.
  • Be sure the concrete is ordered with a low slump (drier mix). This minimizes bleed water.
  • After the final finish is completed, cover the concrete with a Powerblanket® concrete curing blanket. The heated concrete blankets will prevent freezing and keep the concrete at optimal curing temperature.
  • After about 3 days, remove Powerblanket® concrete blankets to allow the concrete to air dry.


Learn More




Powerblanket® | The Ultimate Concrete Curing Blanket – The ONLY Concrete Curing Blanket!


If you pour cement above 50, and temp. Stays in the 50 s, for 2 consecutive days, then temp. Drops below 32 on the third day are you safe?


    Frank, that’s an excellent question.

    Quoting the American Concrete Institute, “Cold-weather concreting, as stated in ACI 306 is, ‘a period when for more than three successive days the average daily air temperature drops below 40 degrees Fahrenheit and stays below 50 degrees Fahrenheit for more than one-half of any 24 hour period.’ This definition can potentially lead to problems with freezing of the concrete at an early age.”

    Please refer to them as the experts here:'

The footings on our house were poured yesterday at 34 degrees on no frost ground. Temps dropped to 20 degrees last night and the contractor didn’t take any actions to protect the footings from the cold temps. Is there anything that can be done now by me to minimize the damage for night number 2 through X? soils are non-heaving back dune sand. Thanks



    That doesn’t sound like optimal placement conditions. Quoting the American Concrete Institute, “All concrete must be protected from freezing until it has reached a minimum strength of 500 pounds per square inch (psi)… If concrete freezes while it is still fresh or before it has developed sufficient strength to resist the expansive forces associated with the freezing water, ice formation results in the disruption of the cement paste matrix causing an irreparable loss in strength. Early freezing can result in a reduction of up to 50 percent in the ultimate strength.”

    You can read more here:'

We had a concrete poured in garage this winter and has tiny fractures all over the entire surface now several months later can it be fixed and what do you think caused it'

    The contractor added to much water and over worked the surface with the trolling machine and caused it to to lift mixtures and rocks to surface due to cold temp'

We would like to pour an exterior concrete slab / sidewalk for an entranceway, what would be the maximum cold temperature that a sidewalk can be poured and cured? thanks,'

what is the lowest temperature I can seal the concrete. it is a dyed stamp job. I’m using a stamps here type sealer to give it more shine'

Have you heard of using antifreeze in the mix of the concrete mix ??'

Today the city about 100′ of roadway in front of house, its 33deg now and gonna be in low 20’s or lower by morning and is not suppose to get above freezing for 3 days, am I correct in being concerned?'

Hi sir I am from India and make wet cast pavers using plastic moulds, in winter I find that demoulding pavers is not possible the next day because concrete has not set ,any suggestions'


    The exposure of concrete to cold weather will extend the time required for it to reach initial set, which may require finishing crews to be available for a longer period. Depending on the actual ambient temperature, protection of a concrete placement may require the use of windbreaks, enclosures, or supplementary heat. It may also be appropriate to adjust the concrete mixture constituents for the effect of ambient temperature on setting time. This may require an increase in cement content, the use of an accelerating chemical admixture, or both.

    The Powerblanket Concrete Curing blankets could be an efficient and reusable solution for you.
    Cure concrete 2.8 times faster than conventional insulated blankets
    Produce cold weather concreting strength of 3,925 psi in 72 hours
    Maintain moisture throughout hydrating process
    Easily installed and removed'

Hello… When the basement of our new house was poured it was well below the temp requirements mentioned above. they brought in heaters and sealed everything off to counter the cold temperature. as a result when they accessed the basement, they said it was “raining” because the condensation built up on the basement ceiling. of course we didn’t know anything about this and even if we did, we wouldn’t have know this may be a problem. well today, about 18 months later, the top layer of our basement floor is continually crumbling into a fine powder. this of course is unhealthy to breath and makes a tremendous mess. our builder is of course trying to “take care” of things as cheaply as possible. we have been told by a local concrete refinisher there is nothing to do except remove it or have more poured on top. the builder has tried sealing it with an industrial sealer, but there was little to no effect. does anyone have experience with this or have any advice?


Leave a Comment

Comment (required)

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>

Name (required)
Email (required)